1. The Refrigerator mould needs to install side locks (straight locks) on all four sides. If you cannot install the side lock, you need to install a taper lock, or a cone lock. The taper lock should be installed horizont...
Regarding the design of the mold insulation system, we will provide you with a detailed introduction below. 1. The detailed structure of the mold frame and core, the cooling water of the mold is very important, in order ...
The characteristic of thermoplastics is that they expand after heating and contract after cooling. Of course, the volume will shrink after pressurization. In the injection plastic molding process, the molten plastic is f...
1. Cavity layout. According to the geometric structure characteristics of plastic parts, dimensional accuracy requirements, batch size, mold manufacturing difficulty, mold cost, etc., determine the number of cavities and...
The SMC molding position of each SMC molded requires annual maintenance. Some SMC mold repair techniques can allow the effective operation of SMC mold components and prevent accidents. Regular maintenance of SMC mold par...
There are many ways to improve the service life of the mold.If you want to increase the service life of the mold and save costs, you can use the method of heat treatment to refine the grain. Using grain refinement to imp...
Copyright(C)2018, Taizhou Huangyan HAOHAO Plastic Mould Factory All Rights Reserved. Supported by HWAQ