News -

Home / News (Page 4)

The development trend of the automotive mould industry
16-05-2019
With the development of high efficiency and automation of automobile stamping production, progressive die will be more widely used in the production of automotive stamping parts. Stamping parts with complicated shapes, e...
What are the surface treatment technologies for molds?
11-05-2019
Mold is one of the important foundations of modern processing industry. With the continuous development of mold forming and processing technology, the requirements for mold materials are getting higher and higher. In add...
The danger of excessive temperature of injection molding machine and its treatment
05-05-2019
There are five major hazards in the temperature rise of the injection molding machine: the thermal deformation of the machine, the viscosity of the oil is reduced, the rubber seal is deformed, the oxidation of the oil is...
Why should we pay attention to the maintenance of the mold?
27-04-2019
Good maintenance and maintenance of the mold can shorten the assembly of the mold, debug time, reduce production failures, smooth production, ensure product quality, reduce waste loss, reduce operating costs and investme...
What is the white edge on the injection mold? How to solve it?
19-04-2019
White edges are injection defects specific to modified polyethylene and plexiglass, and are mostly found on the edge of the part near the parting surface. The white edge is an aggregate composed of a myriad of stretched ...
Several suggestions for the installation of injection moulds
13-04-2019
1. Preparation before installation Confirm the cooling water channel. The depth of the screw into the board is 1.5-1.8 times the diameter of the screw. If the screwing is insufficient, it is easy to slip and there is a r...