News -

Home / News (Page 19)

Mould manufacturing and inspection
27-12-2018
Mould is the basic process equipment produced by the mechanical industry. It is an indispensable tool for the production of industrial products. The performance of the mould made of die steel needs to be supervised by st...
Not only use mould,but also inspect and clean
21-12-2018
Mould maintenance 1. Purpose: To ensure that the equipment can maintain the best performance state and extend the service life to ensure the normal production. 2. Scope of application: Applicable to the repair and mainte...
The reason for the basic mold bursting
13-12-2018
The reason for the basic mold bursting reminds everyone to take more precautions. Analysis of the cause of mold burst: 1. The mold material is not easy to be broken in subsequent processing. 2. Heat treatment: improper q...
Plastic injection mould industry should adjust the direction by the trend
07-12-2018
Faced with the changing market, the mould industry does not only know the traditional business model. In fact, the mould industry has made corresponding industrial adjustments to the market changes. Jiangxi plastic mould...
Mold can still be recycled after it has been used
30-11-2018
Do you know that the mold can still be recycled after it has been used? Everyone knows that there are always plastics for collecting waste products on the street. After recycling these plastics, they can be mixed with ne...
The main reasons for production shrinkage are as follows
24-11-2018
1. The thermal expansion and contraction of plastic. When the plastic mould is moulded, the plastic raw material needs to be melted. At this time, the melting temperature reaches 200 to 300 degrees, and the plastic raw m...