Industry News - News

Home / News / Industry News (Page 10)

Three thermal diffusion techniques to improve the life of plastic molds
28-03-2020
Carburizing Different molds of different materials generally use different heat treatment methods, and plastic molds that use low-carbon steel and low-carbon alloy steel to extrude the cavity generally use the carburizin...
Technology upgrading is the way of mold industry
20-03-2020
According to the data from China mould industry association, the technical content of domestic automobile mould is generally low, and the proportion of high-grade mould is small, especially for high-grade cars. The mould...
Four factors affecting the service life of cold stamping dies
14-03-2020
In recent years, China's cold stamping die products have been continuously expanded in terms of application scope. From the perspective of market conditions, China's cold stamping dies have made great progress in terms o...
Eight matters needing attention for mold repair
06-03-2020
Clean up the metal shovel and dirt all over the mold, showing the true nature of the mold. Refer to the last die-casting product sent for repair with the mold, and carefully check the problems with the mold. Are there a...
Analysis of Three Principles of Mold Material Selection
28-02-2020
the mold meets the requirements of working conditions 1.Abrasion resistance When the blank is plastically deformed in the mold cavity, it flows and slides along the cavity surface, which causes severe friction between th...
Status and Development Prospects of Automotive Stamping Die Industry
22-02-2020
Automotive stamping mold is an important process equipment for automobile production. Its design and manufacturing time accounts for about two-thirds of the automobile development cycle, which is one of the main constrai...